Hot-melt sealing machine

Hot-melt sealing machine

Art. SAHM - The Hot-melt sealing machine makes the final sealing of double glazed units with hot-melt sealer delivered directly by a specific pump unit. The required thickness and dimensions are measured automatically, enabling the robotic automation to manage the process. The hot-melt temperature is controlled by thermo-regulators mounted on the extrusion device and keep the hot-melt at 180-190°C throughout the cycle.

Coupling flat press

Coupling flat press

Art. APThe AP coupling press is rapid and precise in coupling double glazed units up to a thickness of 70mm with one or more cavities and is typically installed down-line to a vertical washing plant.

Coupling press with gas

Coupling press with gas

Art. APGThe APG series couples and presses double glazed units and gas fills the cavity, automatically calculating the volume required. The gas acts as insulation, reducing the heat transmission coefficient and in some cases increases the noise reduction insulation coefficient.

Automatic rotating conveyor

Automatic rotating conveyor

Art. ARCThe automatic rotating vertical conveyor allows to invert the glass pane face in order to lay the low-E coating as required and thus facilitate the production of glazing with 3 or more panes.

Cork pads applicator

Cork pads applicator

Art. CAThe Cork Pads Applicator in situated at the end of the insulating glass line: after the coupling press and before the secondary sealing process. The application is available along 2,3,4 and 5 different height levels, depending on the size of the glass panel.

Corner conveyor

Corner conveyor

Art. ACThe corner vertical conveyor offers total freedom to organise a processing line in the space offered on the factory floor without interrupting the production cycle.

Shape scanner

Shape scanner

Art. SQD00 - The shape scanner controls the glass and determines its shape and dimensions. The scan data is used by the line machinery as a support to the work processes.

Automatic Coating Remover

Automatic Coating Remover

Art. CR – This process prepares the glass for the adhesion of glass sealant in the primary and secondary sealing stages. The machine automatically controls the correct face of the sheet and then removes the film along the perimeter edge.

Ti informiamo che, per migliorare la tua esperienza di navigazione su questo Sito, FOREL utilizza dei cookies.Cliccando su “Accetto” o continuando la navigazione saranno attivati tutti i cookies specificati nell' Informativa estesa ai sensi dell’art. 13 del Codice della privacy. To find out more about the cookies we use and how to delete them, see our privacy policy.

  I accept cookies from this site.
EU Cookie Directive Module Information